AAPEX 2017 will see quite a few changes. One of them is the introduction of the new "AAPEX Technology Intersection". The Technology Intersection is a spot where an exhibitor can secure a 20 x 20 booth space to showcase the future of the automotive aftermarket. This area is for showcasing technologies that may not be available for a few years, but the need to start conversations about them is now.

Click HERE to fill out an application for this section.

Another new exciting change to AAPEX 2017 will be the addition of the Outdoor "AAPEX Mobility Park". This section will be located behind the Sands Expo Center in the LINQ lot outside. This section will host the following areas:


Electric Expo
Scan Tool Theater
Underhood Training

 

Traffic to this new area will be enhanced by moving the intervenue shuttle bus drop-off/pick-up from the Sands garage to it's new location in the AAPEX Mobility Park. In 2016 over 20,000 attendees rode the intervenue buses from SEMA to AAPEX during the three show days. This year they will all be dropped off in the AAPEX Mobility Park. To assist with this change, we will also be opening the doors in the rear of the Sands allowing entrance to the back of Hall A adjacent to booth 1183 on the upper level, and the doors on the side of the Sands to allow entrance to the side of Hall G adjacent to booth 7300 on the Sands lower level. Don't hesitate on reserving your space in this exciting section!

Don’t delay as space in this area is limited and will be assigned on a first-come, first serve basis. To reserve your space, fill out the application HERE or contact Sandra Kulas at: Sandra.kulas@aapexshow.com.

This section will be located behind the Sands Expo, in the LINQ lot outside, and will host the following areas:

  • Electric Expo
  • Scan Tool Theater
  • Underhood Training
  • Mobility Park Car Display

The inter-venue shuttle bus between AAPEX and the SEMA show will drop-off/pick -up at it;s new location in the AAPEX Mobility Park. All components of AAPEX Mobility Park are free to AAPEX/SEMA Registered Attendees.

Tent A

Tent A will give attendees a chance to come up close and view the latest and greatest in scan tool in the automotive aftermarket industry. Each demonstration will be 45 minutes and include tips and tricks to better utilize scan tool technology.

Tent A Schedule

Tent B

Tent B will host 45 minute underhood sessions and show attendees the proper procedures for under the hood work. Sessions start a quarter after each hour, every hour, 9:00 am - 5:00 pm. Seating is first come, first serve.

Tent B Schedule